Hi Folks, I found some awesome downloads in this thread: http://www.newscionxb.com/135-do-yourself/4701-open-directory-scion-xb-shop-manual-pdfs.html
BUT... They do not seem to include what I really need at the moment so hopefully someone can be of assistance.
I have a 2008 Scion Xb that is currently showing check engine codes of P0136 and P0137 so here are my questions:
1) Both codes specifically refer to the O2 Sensor location Bank 1 Sensor 2 - I have tried to figure out exactly where that is and I am pretty sure it is the one on the exhaust pipe under the car - is that correct? (See screenshot below)
2) I see in the documents from the thread above there is a view of the exhaust that shows where the heated oxygen sensor is located but then in the exhaust removal and install documents there is just a line that says to remove/install the sensor with no instructions. Does anyone have a straightforward set of instructions with visual aids or should it be easy enough to figure out once the car is jacked up? I ask this mainly because I saw something somewhere (I can't remember where now) about the wires going up through the floor and you have to pull back the carpet etc... I am hoping that was some other make/model vehicle I was looking at and for the 2008 Scion Xb it is all exterior... anyone know the detail here?
See the screenshot of the O2 Sensor. My concern is where does the other end plug into... and... is this indeed the Bank 1 Sensor 2 location?
3) This one is more a question about the codes themselves - is the P0136 and P0137 specifically for the Bank 1 Sensor 2 sensor or is it possible for those codes to trigger for the Bank 1 Sensor 1 sensor? (or will that have diff codes?)
Any help you can offer would be greatly appreciated!
Thanks,
Linda
BUT... They do not seem to include what I really need at the moment so hopefully someone can be of assistance.
I have a 2008 Scion Xb that is currently showing check engine codes of P0136 and P0137 so here are my questions:
1) Both codes specifically refer to the O2 Sensor location Bank 1 Sensor 2 - I have tried to figure out exactly where that is and I am pretty sure it is the one on the exhaust pipe under the car - is that correct? (See screenshot below)
2) I see in the documents from the thread above there is a view of the exhaust that shows where the heated oxygen sensor is located but then in the exhaust removal and install documents there is just a line that says to remove/install the sensor with no instructions. Does anyone have a straightforward set of instructions with visual aids or should it be easy enough to figure out once the car is jacked up? I ask this mainly because I saw something somewhere (I can't remember where now) about the wires going up through the floor and you have to pull back the carpet etc... I am hoping that was some other make/model vehicle I was looking at and for the 2008 Scion Xb it is all exterior... anyone know the detail here?
See the screenshot of the O2 Sensor. My concern is where does the other end plug into... and... is this indeed the Bank 1 Sensor 2 location?
3) This one is more a question about the codes themselves - is the P0136 and P0137 specifically for the Bank 1 Sensor 2 sensor or is it possible for those codes to trigger for the Bank 1 Sensor 1 sensor? (or will that have diff codes?)
Any help you can offer would be greatly appreciated!
Thanks,
Linda