Scion XB Forum banner
1 - 1 of 1 Posts

130 Posts
I can't speak to the other two, but I did the cargo net install, which involved drilling holes in the side panels (and underlying sheet metal) in the rear cargo area.

I can't remember what size drill bits I ended up using, but you should know that the instructions are WRONG... or, at least they have metric (mm) size drill bits, and it's near impossible to find metric drill bits at the more popular hardware stores in North America.

I converted metric/English and did the best I could, but ended up having to enlarge the holes a couple of times beyond what the instructions say before I could screw the anchors in to the point where I felt like they were a solid grab without worrying that I was torquing them so hard that they would break off in my hand. Just take your time, go slow and gradually enlarge the holes slowly and you'll be fine.

End of the day, it was a clean install but I wish the OEM cargo net had the full length available for storage... that left-hand area with the velcro pockets is dumb and limits the cargo net to only be able to hold about 2-3 full bags of groceries.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.