Scion XB Forum banner
1 - 10 of 10 Posts

·
Registered
Joined
·
254 Posts
I really like this...am considering trying it.

I think i saw your DIY on this...but did it include the AC knobs or just the shiftbox lights?

joe
 

·
Registered
Joined
·
339 Posts
Please post a DIY for us! I need to see where to drill. looks great again!
 

·
Registered
Joined
·
18 Posts
Discussion Starter · #6 ·
these are sort of drop in leds they are leds that are pre soldered with a resistor and all u have to do is wire them into a positive and negative 12v source i will so what i did tomorrow. but the lights that are under the knobs are twist in and power themselves of of metal plates located inside the knob assembly so all i did was drill a small hole in the this piece behind the knob in order to run the wire attached to the led through its not messing up anything its basically a little hole through a thin piece of plastic i will take pics in the morning and show a step by step DIY for yal but its dark outside so the pics will look bad i will do this as soon as i wake up so look for a post around nine or ten tomorrow morning sory about makin yal wait
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top