Scion XB Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter · #1 ·
To all with a RS 5.0 -

Have any of you installed splash guards or are using a CAI?

I was told by a Scion dealer that both the splash guards (due to the body kit) and TRD CAI (due to the unusable bumper vent) are not recommended for the RS 5.0.

So, which CAI are you running and have you had any issues?

And, if you did install splash guards, did you have to modify them at all?

Thanks in advance,

Chris
 

·
Registered
Joined
·
22 Posts
Discussion Starter · #6 ·
The RS bumper kit mounts over the existing bumper. I discovered this when I installed my fog lights.
So, you have the inlet piece that can be popped out from the original bumper. But, then you have a black sticker that simulates the inlet on the RS bumper. I guess if you were handy, you could cut the RS bumper and fit the inlet piece in there, but that is too much work. And knowing my luck, I would probably mess it up.
I'll just go with a short ram kit.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top