Scion XB Forum banner
1 - 20 of 37 Posts

· Registered
Joined
·
166 Posts
Discussion Starter · #1 ·
so i bought a weapon r header plus the s pipe and cel thing. also a strup cat back( 790$ shipped) as soon as i get them i will post pics and pics of installing them. also i will dyno it after! then i will get the unichip and dyno that to see any improvments!! so far all i have is a Tenzo R intake.
 

· Registered
Joined
·
166 Posts
Discussion Starter · #12 ·
well i tried to install it all at once but ran out of time. i got the strup cat back on but i could not get all the bolts off the header. i got them all but the lower one next to the alt. ill try ahain next week when i have more time and better tools. here are some pics



 

· Royal Floor Sweeper
Joined
·
4,338 Posts
For that one, get one of those u-joint "extenders." You'll need that to get the angle. Also, use a deeper socket, but not one of those long deep ones. If not, you'll just round off the nut as the sockets fit poorly and "pop" off when turning.
(I learned this the hard way when taking my header off to paint.)
 

· Registered
Joined
·
783 Posts
is the install hard? I'm thinking about asking for something similar for christmas. but I don't want to have to pay someone to install it.
 

· Registered
Joined
·
166 Posts
Discussion Starter · #18 ·
the strup cat back was easy if the car is jacked up some. still trying to get time to install the heder and s pipe. if i can get that stupid bolt out then i looks pretty easy. and it was all 780 from wesellcarparts. com i thik
 

· Registered
Joined
·
166 Posts
Discussion Starter · #19 · (Edited)
got it all installed! heres some pics. took 2 hours lol in my garage with no power and a flash light. the spare tire jack is my best friend cuz i dont have a floor jack. plus it was about 30F out side lol

out with the old and in with the new. has weapon r cel elbow


inside the frist cat...

are those my valves? lol
 
1 - 20 of 37 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top